1 Ch L-band RF to Fiber Converter
—— YUK1000L Series ——

Transmitter

Receiver
Overview
YUK1000L series L-band optical transceivers are divided into YUK1000L-T series optical transmitters and YUK1000L-R optical receivers, which are used to realize optical transmission of L-band satellite signals (satellite intermediate frequency signals). The optical transmitter outputs the high-frequency head, connects to the L-band satellite signal through the coaxial cable, and converts it into an optical signal. The optical receiver receives the optical signal sent from the optical transmitter and provides RF signal output.
The RF input of the optical transmitter can provide operating voltage to the Ku-band or C-band downconverter (satellite tuner) connected outdoors through panel control, and can complete the horizontal (H) and vertical (H) of satellite reception on this machine. V) Polarization conversion, the optical transmitter has AGC control function.
Product Features
l 1U, 19' standard rack
l Working RF frequency: 900MHz~2150MHz
l RF input level has a wide operating range
l Horizontal polarization H/vertical polarization V switching
l LNB tuner power supply on/off control
l AGC/MGC mode selection
l RF level AGC/MGC control/adjustment
l Laser power display
l Laser operating current display
l Remote network management can be performed through Etherne
l Maximum transmission distance: 80km
l Suitable for transmitting video, audio and data modulation signals of various formats of L-band
l The transmitter uses low-noise, high-performance DFB laser to ensure high indicators and high reliability of the device
l Low power consumption design, low heat generation, improved stability, and meets environmental protection requirements
l Monitor parameters and report to network management system
l Both transmitter and receiver boards have detection interfaces
Specification
The specifications listed below are valid over the specific bandwidth and operating temperature ranges described in this section.
|
RF |
RF connector: FL10 |
Input impedance: 75Ω |
RF frequency range: 950~2150MHz |
RF input reflection loss: ≥10dB |
Input singal range: -20dBm~-50dBm |
Flatness in band: ±0.5dB (± 0.25db within any 36MHz bandwidth) |
Intermodulation*: ≤-55dBc |
SNR*: ≤-55dBc |
RF input port: output power supply ≥DC300mA |
Frequency converter horizontal (H) polarization voltage 12V/vertical (V) polarization voltage 12V conversion |
|
Note: The * mark is when the optical receiver input optical power is -8dBm, the optical transmitter module is at the nominal input level, |
dual carrier 1.5GHz and 1.55GHz mode, and the receiver output level is -35dBm tested. |
|
Optical |
Optical connector: SC/APC or FC/APC |
Optical wavelength: 1310±20nm or 1550±20nm (other CWDM wavelengths are optional) |
Optical reflection loss: ≥50dB |
Output optical power: 0dBm to +10dBm ( according to transmission distance) |
|
Common Parameter |
Power consumption: ≤3W |
Operation temperature range: -25°C~ +50°C |
Storage temperature: -45°C~ +85°C |
Relative humidity: 15%~95% (noncondensing) |
|
Note: The optical output power is specified in the following way: one end of the optical fiber link is inserted into the optical flange of the |
transmitter module and the other end is inserted into the optical power meter and connected through a 1m jumper. |